Version Notes
HW Requirements: ALI 5.221 or ALI 5.222
cable
MASTERLIGN
1.18
- Sleep Mode available only with Hardware version
3. You can check your hardware version with F94.
Previous hardware versions cannot be retrofitted to benefit from this new
option.
- Save Function
If you are working on a file and you
press SAVE, the Masterlign automatically assigns the next available file
number.
But if you press SAVE again while in the same file then the Masterlign displays and flashes the current file number so that you
can
append your changes to the open file. If you do not wish to append a change
then you must overwrite the suggested number.
You
can compare the new Masterlign
Save Function to the PC functions SAVE AS and SAVE.
- Review of soft foot values possible without
measurement:
- Press the soft foot key
- Press ENT (If the beam is within range,
the existing soft foot values will immediately be displayed and
can be
cycled through with the left/right arrow keys.) Otherwise (in other words
if beam is END or OFF),
- Press ENT again. Cycle through soft foot
values with the arrow keys.
MASTERLIGN
1.17
- Limit on distance from
laser to prism is removed;
- "Quick" header on report changed to "MASTERLIGN".
 Back
to Upgrades and Downloads Page
|
